Electrical Connections - Erreka CLEVER02(M) Manual Del Instalador

INSTALLATION
4

ELECTRICAL CONNECTIONS


Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, and always earthed.

Check the manufacturer's instructions for all the elements installed.
 Make the connections with the power supply cut off.

Electrical connections
R.E. Connector for plug-in receiver
(RECEIVER2)
ANT Cable connectors for antenna
A.T. (ST1) Key command for opening (in all modes)
and for closing (in step-by-step mode only)
C.T. (ST2) Key command for closing (except in step-
by-step mode)
SG.A (FT1) Opening safety device (mechanical strip or
photocell)
SG.C (FT2) Closing safety device
(photocell or mechanical strip)
30
Installation Guide
GND ANT
(1) ST1
(2) GND
(3) ST2
(4) FT1
(5) GND
(6) FT2
RECEIVER2
CLEVER02: 230V
CLEVER02M: 125V
AUX Output (24Vac, 350mA). Constant output in
order to feed peripheral devices
DEST Flashing light (max. 60W)
CLEVER02: 230V; CLEVER02M: 125V
RLX Voltage-free relay output (operational only
in step-by-step mode)
A Operator
FCA Operator opening limit switch
FCC Operator closing limit switch
M Operator motor
C Operator capacitor
SW1 Main switch
CLEVER02:
230Vac, 50Hz
CLEVER02M:
125Vac, 60Hz