Noise Pollution; Safety Notes For Rechargeable Battery And Charger; Installation; Mounting The Blowing Tube (11) - AL-KO SOLO LB 4250 Manual De Instrucciones

Installation

pulse. The risk increases at
low temperatures.
■
Take long breaks during your
working day so you can re-
cover from the noise and the
vibrations. Plan your work in
such a way that the use of ap-
pliances that generate strong
vibrations is spread over sev-
eral days.
■
If you notice an unpleasant
sensation or discolouration of
the skin on your hands when
using the tool, stop work im-
mediately. Take sufficient
work breaks. Without suffi-
cient breaks, a hand/arm vi-
bration syndrome can occur.
■
Minimise your risk of being
exposed to vibrations. Main-
tain the tool according to the
instructions in the operating
instructions.
■
If the tool is used frequently,
contact your dealer to pur-
chase anti-vibration accesso-
ries (e.g. handles).
■
Avoid working with the tool at
temperatures below 10 °C.
Define how the vibration load
can be limited in a work plan.

3.3 Noise pollution

■
A certain level of noise expo-
sure from this appliance is in-
evitable. Carry out noisy work
442509_a
at approved and specified
time periods.
■
Observe rest periods as nec-
essary and restrict the dura-
tion of the work to a minimum.
■
For your personal protection
and protection of persons in
the vicinity, appropriate hear-
ing protection must be worn.
■
National and/or regional regu-
lations may restrict the use of
this device at certain times of
the day.
3.4 Safety notes for
rechargeable battery and
charger
Heed the safety instructions for
the rechargeable battery and for
the charging unit in the separate
operating instructions.
4 INSTALLATION
WARNING!
Danger if assembly is not carried out
completely!
Operation of an incompletely assembled
appliance can result in serious injury.
■
Only operate the appliance when it
is fully assembled.
■
Do not insert the battery into the ap-
pliance until it is fully assembled.
■
Check that all safety and protective
devices are in place and functioning
correctly before switching on.
4.1

Mounting the blowing tube (11)

1. Push the blowing tube (11/1) into the ma-
chine up to the stop (11/a).
2. Lock the blowing tube (11/1) by rotating it
(11/b).
29