Operation; Using The Appliance As A Vacuum Cleaner; Vacuuming With The Water Filter - LAVOR Pro GV EGON VAC Instrucciones Para El Uso

• Fit the solids filter (R) completely along with the curved ends
• Make sure the unit is properly assembled; check if the filter, lower
filter cover and solids filter are completely and properly fitted
• Put back the filter assembly with float (O) in the tank (M)
• Keep the handgrip (T) lifted and reposition the tank
(M) onto the appliance
• Lower the handgrip (T)
• Close the handgrip (T) by pressing downwards and making sure that the buttons (U) return to
their initial position properly Once in position it should click

Using the appliance as a vacuum cleaner

7.1
To select the suction power (from level 1 to level 4), press
the remote suction button (27) on the handgrip (23) at
short intervals; the selected suction power level LED indica-
tor (28) will light up.
It is possible to change the power level both when the
suction is on and off.
To switch the vacuum on and off, hold down the remote suc-
tion button (27) for about two seconds. If the quick connec-
tor (24) is pulled out, the suction power level will restart
from level 1 the next time is used.
CAUTION! Never vacuum if the microfibre filter (P) is
not installed.
Vacuuming with water filter
7.2
For best filtration results, add water to the tank (M). The
water filtration allows you to "capture" the dirt so that the
outbound air always remains clean and therefore you clean
more effectively.
Proceed as in chapter "6.1 Preparing the vacuum" then
replace the microfibre filter (P) with the sponge filter (Q)
(chapter "6.3 Replacing the filter")
of normal tap water to the tank until you reach the MAX
level shown on the tank
CAUTION! Do not put detergents or inflammable sub-
stances in the tank. Never vacuum if the sponge filter
(Q) is not installed.
EN
picture 9

7 OPERATION

(picture 12-13)
(picture 14)
.
(picture 15)
(picture 11)
picture 10
. Add one litre
picture 11
picture 13
picture 14
picture 12
picture 15
8