Using The Accessories; Window Wiper (13) - LAVOR Pro GV EGON VAC Instrucciones Para El Uso

picture 19
The attachments can be directly connected to
the handgrip (23) or, depending on your needs,
to the extension tubes (2)
• Fitting the attachments: fit completely until
the lower hooking lever (30) is hooked.
• Disconnecting the attachments: press and
release the lower hooking lever (30) and
pull out the attachment.
CAUTION! Make sure it is properly fastened
by pulling it slightly.
CAUTION! Never separate the attachments
when steam is coming out; you could burn
yourself.
BIG BRUSH (3)
The big brush is provided with an articulated
connection, wheals, steam diffuser and a suction
unit. Three different fittings can be attached to it:
floor fitting (4)
•
carpet fitting (5)
•
liquid fitting (6)
•
To assemble the fitting:
• Move the top slides outwards
• Turn the big brush (3) upside down
• Fit the required fitting and make sure it is
properly oriented (the wide part must face
forward)
(picture 20)
• Fasten the fitting by moving the two top
slides inwards
(picture 21)
EN

8 USING THE ACCESSORIES

picture 20
(picture 19)
picture 21

WINDOW WIPER (13)

The window wiper is provided with a steam
diffuser, a window wiper sponge, a rubber
squeegee and a suction nozzle.
CAUTION!
Exclusive temperature differences between
the glass window and the steam can break
the window.
With extreme outside temperatures, preheat
the window with steam at a distance of about
30-50 cm.
Then spray the steam all over the surface of the
glass to compensate the temperature differen-
ces and to avoid stressing the glass surface.
USE
• Use the window wiper to wipe the surface
starting from the top downwards.
• Slightly press the window wiper sponge to
remove dirt.
• To dry, vacuum the surface by putting the
window wiper rubber strip against it.
• For slightly dirty surfaces, use both steam
andì vacuum at the same time.
WARNING:
To keep the attachment dripping, complete
the steam delivery and continue to vacuum
for a few moments in order to allow the
vacuumed liquid to go up the suction ducts.
After each cleaning operation, clean the
window wiper rubber strip with a clean
cloth. Proper window cleaning, with no
lines, will be guaranteed only if a clean and
outstretched strip is used.
picture 22
10