Ferroli GN4 N Instrucciones De Uso, Instalación Y Mantenimiento página 5

GN4 N
D Connect the panels together, using the screws 1, the washers 2 and the nuts 3,
reinforcing the bottom parts using the blades 4 fastened with the screws 5.
E Loosen the nuts "A". Insert the side fastening bracket "B"
F Fasten the sides to the rear wall "A" using the screws "B".
B
A
B
G H
G Fit the side to the bracket "A" and fasten it using the screws "B" (right
side view). Repeat the operations in point G for the left side.
H Fasten the sides to the rear wall "A" using the screws "B".
I Fit the wiring protection case "A" using the screws "B" on the sides.
L
L Fit the control panel to the sides using the tabs "A". Place
the reinforcement spring "B" between the head of the screw
and the tab.
A
O
O Fit the upper panel "A".
P Fit the top cover or covers "A", according to the length of the boiler (see table 1, sequence
C).
B
B
B
A
B
A
B
P
Cod. 3541A511 - Rev. 01 - 03/2015
A
E
M
M Insert the 3 bulbs (safety thermostat, boiler thermostat and
thermometer).
N Fit the lower front panel "A".
A
B
A
B
F
B
A
I
N
A
5