Configuration - Velleman HAMGSM133 Manual Del Usuario

Make all necessary connections (I1, I2, O1, O2).
•
Connect the power supply [1] (not incl.).
•
Close the housing (not incl.).
•
Configuration
7.
There are 3 ways to set up the device:
through call (only at start‐up)
•
through SMS
•
through USB (USB interface required, not incl.).
•
Through call (only at start‐up)
When the device is supplied with power, "LD5" will immediately
flash at 1 Hz frequency. The HAMGSM133 will try to connect to the
GSM network. When connected, "LD5" will briefly flash every 2
seconds. After the system initialization (which may take several
seconds), the device alternately illuminates yellow LEDs "LD3" and
"LD4" to indicate the "configuration call" on hold mode for 3
minutes. If during this time the unit receives a call, it stores the
caller's number (to which reply SMS will be sent) in the first memory
location and LD3 and LD4 turn off
Note: the caller ID of the used mobile phone must not be hidden
(callers' phone number must be visible when calling another mobile
phone).
At the end of the hold mode the yellow LEDs are switched off and
the device waits for a configuration SMS.
With the same phone used to make the first setup call, it is also
possible to switch the relay status.
Through SMS
This mode takes full advantage of the device with operations as
output switch, output status query, inclusion of additional phone
numbers to activate the relay, inclusion of numbers for door opening
function, reception of reply messages; change output signals timing
and, in general, set the HAMGSM133 with all parameters via simple
SMS. A full reset to restore the default settings can also be made via
SMS. The syntax for all available commands can be found in §8
Configuration SMS.
Through USB (USB interface required, not incl.)
This mode easily allows you to setup the HAMGSM133 through a
computer (with special software) connected via an USB interface
(not incl., Ref. HAMGSM133/USB).
It is possible to manage all programming and settings as well as
change the list of enabled users. This speeds up the initial set‐up and
saves on the cost of SMS. After starting the software, verify that the
communication speed is set to 9600 Baud (8, N, 1).
Refer to the full user manual for more information on the installation
31.05.2011
HAMGSM133
6 ©Velleman nv