Using The Video Door Phone; Settings; Intercommunication Between Monitors Of Different Dwellings; Additional Menus On The Roadside Panel - Extel WEVPMH 001 Instrucciones De Uso

8
INSTRUCTIONS FOR USE
a. Using the video door phone
The LCD screen of the panel presents simultaneously the 2 following screens:
with the 8 and 0 keys)
Then enter the No. of the dwelling.
monitor "TALK" key to communicate with him.
monitor off.
(Caution, the max. number of monitors on which can be viewed at the same time the video of the roadside panel is limited,
see chapter 9 "configuration").
Note that the time outs indicated below are settable in the "general configuration" menu – "9- timing". (chapter 9)
Note that the opening function is only valid if the screen is turned on and in communication mode.
b. Settings
Setting audio volumes.
You can access a 1st setting by the menu of the roadside panel.
On the keypad type #9008, administrator code ("66666666
Fig 1
CFI EXTEL WEVPMH 001 - 03/2010 - V1
12GB
9" and "#" to access the list of names. (navigate in the menu
monitor" key to turn the
monitor" key.
monitor".
unlock" key,
Fig 2 Fig 3
2" then #
1# then *
3 and 6 keys.
#9009.
It is also possible to modify the sound level of a single monitor.
See setting Chapter 10
c. Intercommunication between monitors of different dwellings
To communicate between 2 monitors (of a same dwelling or between dwellings), press the "call" key, a menu opens.
Select "appel intercom" and validate with the ">" key
Type the No. of the monitor you want to call with the <, >, +, - keys
Then press the "Talk" key of the monitor.
A ring tone is emitted on the called monitor, and then just press the "Talk" key of the monitor to answer.
Note that a call from the roadside panel has priority and that the current communication will be stopped between moni-
tor.
9

ADDITIONAL MENUS ON THE ROADSIDE PANEL

#
* to cancel or return to previous menu.
To enter the "configuration" menu, on the keypad type #8001, administrator code
1- Non used
2- Non used
is in position I or ON
4- Determines the maximum number of monitors to be in surveillance mode at
the same time
5- Non used
6- Non used
7- Allows selecting the number of characters to type on the keypad (by default 4)
to select the No. of the dwelling (enter the menu, type "0" for 4 characters,
"1" for 3 characters, "2" for 2 characters)
8- Allows modifying the administrator code (factory "66666666")
CFI EXTEL WEVPMH 001 - 03/2010 - V1
Talk" key of the corresponding monitor.
1 and 4 keys.
Talk" key of the monitor.
66666666".
SW1
13GB