Installation - Extel WEVPMH 001 Instrucciones De Uso

3
SPECIFICATION
1. 13 cm colour screen
2. Microphone to communicate with the roadside panel.
3. Communication with the roadside panel.
4. Control of an electrical lock or strike (12 VDC output
on the L+ L- terminals of the power supply unit).
tion.
6. Call button in intercommunication mode
7. Menu browser.
8. The "in use" indicator turns on when a communication
is established on the network (note that the roadside
panel/ monitor communication has priority over the inter-
communication).
9. If the "mesg" indicator is turned on, function "do not disturb" active.
10. At the back of the monitor, RJ45 connector to connect to the distributor.
1. Microphone: allows the visitor to communicate with the internal unit
2. Colour lens of the camera, CCD with adjustable automatic iris.
3. Infrared LEDs for half-light vision, for night vision use an additional lighting system.
(Not visible to the naked eye)
4. LCD screen to view the list of names, and the menus (non accessible by the visi-
tors)
Also to type the secret code for the access opening or to program the video door
phone (if you are administrator)
6. Speaker: allows to be heard outside.
1. Power supply P+ P-
2. Next distributor output
3. Previous distributor or roadside panel input.
4. Inputs for 4 monitors
5. Switch: Put imperatively the last distributor in "HI" position
We count 1 distributor for 4 monitors, use one or several additional
distributor(s) according to the number of monitors.
CFI EXTEL WEVPMH 001 - 03/2010 - V1
4GB
-
1 2 3
4 5 6
7 8 9
0 #
*
Fig 3
4

INSTALLATION

Before the installation
IMPORTANT
IMPORTANT
1. Remove the panel of the surface-mounted housing. To do so, remove the cover (1) the screw (2) and the shim (3)
2. Lift the panel (4) and remove it.
Fig 1
the power supply unit (2 cables)
5. Connect the cables to the roadside panel
6. Check the orientation of the lens (readjust as shown below, if necessary)
7. Fix the cover back (8) and replace the panel in the surface-mounted housing.
8. Fix the shim back (3) with the screw (2), replace the screw cover (1)
To optimise the protection of your roadside panel, do not expose the camera to direct sun light
or a reflecting surface.
5
10
Fig 2
6
Setting the lens (fig 6)
If necessary, it is possible to adjust the orientation of the
camera (only a few degrees)
Remove the panel of the surface-mounted housing.
At the bottom of the panel, remove the screw (7) and
then the cover (8)
Then you access the orientation button (9)
Once adjusted, replace the panel.
If you try your product before installing it, make sure not to do it with the
roadside panel and the monitors in the same room, otherwise the video door
phone will produce a shrill sound (Larsen effect).
Put a silicon gasket on the upper half part between the surface-mounted
housing and the wall. The lower part must be aerated to avoid condensation
and premature oxidation of electronic products (fig 4(10)).
3
1
2
4
Fig 4
CFI EXTEL WEVPMH 001 - 03/2010 - V1
Fig 5
Fig 6
5GB