Registration Of The List Of Names On The Roadside Panel; Registration Of Monitors; Registration Of The Access Opening Code Via The Keypad Of The Roadside Panel; Configuration Of The Monitors - Extel WEVPMH 001 Instrucciones De Uso

b. Registration of the list of names on the roadside panel
First it is important to know that the keypad works as a mobile phone keypad.
Namely:
Key 1: upper-case, lower-case letters
Key 2: a,b,c
Key 3: d,e,f
Key 4: g,h,i
Key 5: j,k,l
Key 6: m,n,o
Key 7: p,q,r,s
Key 8: t,u,v
Key 9: w,x,y,z
Key *: delete
i
Key 0: _ ,
On the keypad type # 8009, administrator code "66666666" and then type "4" (list of names).
Type "2" then #, select "1" (Add), then type "0001" and write the name of the 1st occupant. # to validate, then type "0002"
and write the name of 2nd occupant etc...
(Note that the part in [ ] changes automatically in letter mode)
Type * until you exit the menu.
Preserve the list of occupants and the corresponding numbers (Available memorandum on the last page of the manual).
c. Registration of the monitors
Sur le clavier taper #8003, code administrateur « 66666666 ».
Then press twice the "call" button on the monitor, a beep is emitted and the No. is displayed in the box "old M code", and
then type the No. corresponding to the name created chapter b, validate by #.
CFI EXTEL WEVPMH 001 - 03/2010 - V1
10GB
d. Registration of the access opening code via the keypad of the roadside panel
On the keypad type #8002, administrator code "66666666".
You can parameterize 2 opening codes. Caution, these two codes open the same access.
and a 2nd code (which will be regularly changed, to give to occasional visitors).
1" then enter your new 4-digit access code, validate by #
2" then enter your new 4-digit access code, validate by #
Caution, some codes are prohibited (as they are identical to programming codes), an "error" message is
displayed on the screen to inform you, then choose another code.
The control time is settable (from 5 to 14 s). Refer to chapter 9, "configuration", "3 opening times".
7

CONFIGURATION OF THE MONITORS

a. The monitors are factory set in French
If necessary proceed as follows to change the language: press twice the > key of the monitor, the following screen displays.
Go to "configuration" by typing the key – and press for 2s the key "unlock".
Choose a language, then validate by the "menu" key. 1 beep indicates the valida-
tion of the language.
Now your installation can work properly.
Other settings or menus are available on the roadside panel or the
monitors, and we advise you to know them in order to optimise and
protect your installation.
(See chapters 9 and 10)
CFI EXTEL WEVPMH 001 - 03/2010 - V1
11GB