Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of the Exo Terra
Included with the Exo Terra
will allow you to easily clamp the unit onto the rim of the terrarium
(A). It can be placed on any rim with a width up to 24,5 mm (1 inch).
A
1. Loosen the mounting bracket's attachment screw.
2. Position the mounting system on the preferred place with the
screw aimed to the outside of the terrarium (B).
3. Affix it to the rim of the terrarium by tightening the mounting
bracket's plastic attachment screw.
4. Do not over-tighten.
5. Continue by inserting 2 x type AA batteries in the battery
compartment (batteries not included).
6. Mount the device on the mounting bracket. To obtain a good
stability, the food chamber has to be placed in the opposite
direction of the attachment screw (B).
4
7. Gently tap the Turtle Feeder to make sure that it is firmly attached
to the rim of the terrarium.
B
Programming the Exo Terra
SET button: Select local time and feeding times
FEED button: (manual food release) press this button to release
additional food or to test the functionality of the device; the food
chamber will rotate once.
HR & MIN button: after pressing the SET button, the respective
symbol (local time or feeding time) blinks and can be set with the HR
and MIN buttons
1. Set LOCAL TIME or clock: Press the "SET" button once. A "clock"
symbol will blink. Push the "HR" button to set hour time and the
"MIN" button to set minutes.
Turtle Feeder on the terrarium:
®
Turtle Feeder is a mounting bracket that
®
Turtle Feeder
®
2. Set FEEDING TIME 1: Press the "SET" button again. 00:00 will be
displayed. The symbol for Feeding time 1, the digit "1", will blink.
Press the "HR" button to program hour of first feeding time. Press
the "MIN" button to set minutes. To set another feeding time
proceed to point 3. To end setting the feeding times press "SET"
until all the feeding time symbols (digits) have stopped blinking.
The blinking arrow will show the feeding time that is up next. The
device is now programmed.
3. Set FEEDING TIME 2: Press the "SET" button. 00:00 will be
displayed. The symbol for Feeding time 2, the digit "2" will blink.
Press the "HR" button to program hour of first feeding time.
Press the "MIN" button to set minutes. To set more feeding times
repeat the steps mentioned above. To end setting the feeding
times press "SET" until all the feeding time symbols (digits)
have stopped blinking. The blinking arrow will show the feeding
time that is up next. The device is now fully programmed. If the
batteries have been replaced or removed, the Exo Terra
Feeder will need to be re-programmed. If no numbers are shown
on the display please check the batteries for proper installation
or replace them.
Preparing the Exo Terra
Turtle Feeder:
®
1. Remove the food chamber from the mounting bracket: gently pull
the food container and remove it from the control panel (C).
C
2. Remove the transparent cover from the food chamber. Insert the
food, for example Exo Terra
Turtle Pellets. The food should not be
®
compressed in order to ensure an even release.
3. Close the food chamber by
putting the transparent cover
back into place. Affix the
container on the control panel
and attach the feeding unit to
the terrarium.
4. Adjust the feeding portions
with the controller of the
dispensing door (D). Test the
quantity dispensed by pressing
the FEED button. Adjust if
necessary. Generally Aquatic
Turtles need to be fed 1-2
times a day. The amount of food
dispensed should be consumed
in 5-10 minutes. Scoop out the
remaining food and discard.
®
Turtle
D
Publicidad
