OK. OKR 120 Manual De Instrucciones página 11

COMPONENTS
A. SNOOZE / DIMMER button
B. TIME SET / COOK TIMER button
C. PRE.-/ ALARM 1 button
D. PRE.+/ ALARM 2 button
E. SLEEP button
F. Display
G. Illuminated On/Off
H. Volume button VOL-
I. Volume button VOL+
J. Button SKIP-
K. Button SKIP+
L. Button AMS / MEM.
M. Battery compartment
N. Power cord with plug (not shown)
O. Wire antenna
P. Drilling template (not shown)
BEFORE FIRST TIME USE
Remove the product and accessories carefully from the original packaging. Inspect the delivery contents
for completeness and damages. Should the delivery contents be incomplete or damaged, contact your
sales outlet immediately.
ASSEMBLY
Before installation, make sure that there is an electrical outlet nearby.
• Take the enclosed template with the hole spacing and hold it to the desired location.
1
• Mark the 4 holes or measure them.
• Drill the 4 holes.
• Place the spacers on the provided bracket and fix the radio with the 4 screws, e.g. on the
underside of a hanging cabinet.
Warning!
Do not install the product above a cooker.
INSTALLATION AND POWER SUPPLY
Installation
For optimal reception, extend the antenna fully and adjust it. Connect the power plug to the mains.
2
Back up battery
Insert batteries to enable the clock continues operating during a possible power failure. After the
3
mains power remains, the correct time will appear on the display.
1. Open the battery compartment.
2. Insert 1 x 3 V button cell (Type CR2025, not included). Make sure the polarity is correct as
indicated.
3. Close the battery compartment.
Note:
Display, radio and alarm will not function during back up operation.
IM_OKR120_170824_V03_HR.indb 11
11
button
EN
24/8/17 5:20 pm