Epson EB-465i Guia De Instalacion página 15

C
Attach the setting plate to the wall plate
(1) Hang the setting plate hook onto the wall plate bar (
(2) Lift up the setting plate and pass the cables through it (
Caution
Take care not to trap the cables between the setting plate and wall plate.
(3) Tighten the two M8 x 15 mm hexagon socket head cap bolts and two M8 x 45 mm hexagon
socket head cap bolts supplied with the setting plate so that the setting plate becomes
vertical against the wall (
Use the two M8 x 45 mm hexagon socket head cap bolts to adjust the vertical slide.
s p. 20
Setting plate
D
Secure the projector to the setting plate
(1) Loosen the two screws and remove the cable cover from the projector.
C
).
Screws (2)
15
A
).
B
).
Wall plate
Wall plate bar
Setting plate hook
Cables
M8 x 15 mm hexagon socket
head cap bolts (one on left
and one on right)
M8 x 45 mm hexagon
socket head cap bolts (2)
Cable cover