Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.2
System requirements
The following minimum requirements must be fulfilled
by the PC on which the system software MT-Module is
to be installed:
R
CPU Intel / AMD, 800 MHz or higher
R
Windows operating system: WIN XP, WIN Vista
(32/64 Bit), WIN 7 (32/64 Bit) or WIN 8 (32/64 Bit)
R
Minimum of 1 GB RAM main memory
R
Minimum of 5 GB free hard drive space
R
A free USB connection for the FSA 720 (recommend-
ed is a direct connection without any interposed
USB hub).
R
PS2-connection for connecting remote control
receiver. Please note hereto the specifications of
the laptop / PC manufacturers in the manual. Under
certain circumstances an additional specific adapter
cable may be required.
R
DVD disk drive for ESI[tronic]
R
Screen resolution: 800*600 with 256 colors or higher
i
When operating the FSA 720 measuring module
faults may occur, if the PC or other components (e.g.
mouse, connecting cables) are used that are not
provided by Bosch.
Robert Bosch GmbH
Product description | FSA 720 | 19
3.3
Delivery specification
Description
FSA 720 measuring unit
Power pack
1)
with main connection cable
TM
USB connecting cable (2 m)
Temperature sensor car
Trigger clamp
Primary connecting cable (UNI 4)
Multi measuring cable CH1
Multi measuring cable CH2
Measurement lead with voltage divider
Current clamp 1000 A
Sensors 3 * KV– / black
Sensors 3 * KV+ / red
Stroboscope
Connecting cable B+/B–
Hose line
Adapter cable for clip-on sensor
CD CompacSoft [plus]
DVD ESI[tronic] 2.0
DVD ESI[tronic]
Connection set for vacuum measurement
Cable tie 2x for strain relief
(USB connecting cable and
power pack supply line)
Accessory kit with
Test prods black and red
Connecting terminals black
Accessory set with
Black and red test prods
Black and red pick-off clips
Black, red, gray adapter connectors
Operating instructions
Not always included in delivery, depending on the version ordered
1)
Adapter cable 1 684 465 513 must always be connected
2)
between terminal socket FSA 720 (see Fig. 2; Pos. 4) and the
connecting cables for the clip-on sensor when measuring speed
with the clip-on sensor.
!
The measuring probes included in the test prod set
(1 687 010 153) can only be used for measurements
below 30 volt.
3.4
Special accessories
Information on special accessories, such as e.g. vehicle-
specific connecting cables, additional measuring cables
and connecting cables can be obtained from your
Bosch representative.
Order number
1 687 022 911
1 687 023 601
1 684 461 106
1)
1 684 465 507
1 687 230 036
1 687 224 957
1 684 462 563
1 684 460 258
1 684 460 259
1 687 224 300
1 687 224 968
1 687 224 848
1 687 224 849
1 687 022 767
1 684 460 195
1 680 712 234
1 684 465 513
2)
1 687 370 275
1 987 P12 037
1 987 729 601
1 687 010 145
1 681 316 008
1 687 010 153
1 687 016 118
1 689 979 894
1 689 979 922
|
1 689 979 894
2014-08-28
en
Publicidad
Tabla de contenido
