Walgreens WGNBPA-240BT Manual Del Usuario E Instrucciones De Programación página 25

NOTE:
• This monitor automatically returns to standby mode
approximately 1 minute after last operation. You may
also press the "START/STOP" button to return to
standby mode.
• To interrupt the measurement, you may press the
"START/STOP" button (recommended) or "MEM"
buttons. The cuff will deflate immediately after a button
is pressed.
Using Triple-Check Measurement Mode:
1. Please make sure the Triple-Check switch, located on the side of the
unit, is in the ON position.
2. Press the "
the "START/STOP" button to confirm the chosed user.
3. With the cuff wrapped around your arm, press the "START/STOP"
button. Do not inflate the cuff unless it is wrapped around your arm.
All digits will light up to check the display functions. The checking
procedure will be completed after about 3 seconds.
NOTE: The Check-with-Confidence™ icon
the feature is on.
4. After all symbols disappear, the display will show "00". The monitor
is ready to measure and will automatically inflate the cuff to begin
measurement.
5. When the measurement is completed, the cuff will deflate entirely.
Systolic pressure, diastolic pressure, and pulse will be shown
simultaneously on the LCD screen. The measurement is then
automatically stored into memory.
Triple Check
ON
" button. After the user number is selected, press
24
OFF
will stay on the screen if