Installing The Monitor - Extel IRON 2 Instrucciones De Uso

3. Name Holder and Call Button: when this button is pressed, the bell can be heard both inside and outside, the
monitor and the camera are activated and the name holder lights up.
4. Mounting screws for the panel without the frame. Remove this panel to access the connection terminal and the
mounting holes for the outdoor station.
5. Mic, for communicating with those inside.
6. To write your name on the nameplate, carefully remove the front part of the name holder using a small screw-
driver.
4. INSTALLATION
Note: If you test your product before installing it, ensure that you do not test it with the outdoor station and the
monitor in the same room to avoid the videophone emitting a shrill noise (Larsen effect).
a. Installing the outdoor station
1. Detach the front panel of the camera unit by removing the 2 screws (a)
2. Run the 2-wire cable coming from the monitor and the cable coming from the strike plate and/or the cable for
the automatic opener control through the compression gland (b).
3. Attach the outdoor station to the pillar with 2 screws using the holes (c).
4. Connect the wires to the terminal (d)
5. The camera "ball" (e) can be adjusted without tools. (chap. 7.d)
6. 2 settings are accessible at the top of the outdoor station: (chap. 7.d)
To adjust the settings, use a small screwdriver, turning it gently to avoid excessive force on the stops.
(f), left, volume setting for the outdoor station loudspeaker.
(g), right, volume setting for the loudspeaker on the monitor.
7. Micro-switches (h) to configure the outdoor station address according to the installation.
8. Refit the front plaque, securing it by replacing the 2 crews at the bottom of the outdoor station (a).
Firmly position the front in the notches located at the top of the outdoor station (j).
Important: Do not put screws into the microphone hole (5, fig 3)
Important: Insert a silicon seal on the upper half between the outdoor station and the wall (i, fig.4)
Do not install a silicon seal on the lower part to avoid any condensation resulting in premature oxidation of the
electronics. *Do not use acetic acid-based silicone (vinegar odour)
Important:
Tip: we recommend that you use protective sleeving when doing the cabling in order to protect the cables against
breakage and bad weather.
b. Installing the monitor (
1. Attach the wall bracket
2. Connect the 2 outdoor station wires and the 2 power supply wires (chap 5.a)
wiring diagram (fig 6 for basic installation)
3. Position the monitor on the wall bracket.
4. Once the outdoor station has been connected, connect the 230 V~ power supply to the modu lar adaptor (for
installation in compliant with current standards, NFC 15-100 in France)
Make sure the power supply polarity is correct.
c. Installation of the power supply
- Position the modular adaptor on a DIN rail in a modular panel or install it on a bracket with the 2 black pins
clipped to the edges of the power supply.
5. WIRING
To avoid the risk of parasites and malfunctions, to no run the videophone cable through the same sleeving as the
electrical cables.
GB3
(fig. 4)
No not point the camera directly towards the sun, or opposite a reflective surface.
fig. 5)
CFI EXTEL IRON 2 - V1 - 09/2013
,
paying close attention to the