1 GENERAL INFORMATION
1.1 Introduction
Dear Customer,
First of all we wish to thank you for the trust placed in us by purchasing one of our products. Please read and
carefully follow the advice given in this installation, use and maintenance manual in order make best use of the
product.
1.2 Using the manual
The Manufacturer reserves the right to make technical or aesthetic changes to the products at any time without
notice.
Stove installation, use and maintenance operations must comply with the requirements given in this manual as well
as the European, National, Regional, Provincial and Municipal regulations.
The drawings, measurements, diagrams and any other configurations are given only by way of example.
This manual is an integral part of the product; make sure it always stays with the stove, even if sold, transferred to
another owner or installed in another place, so that it can be consulted at any time.
If lost or damaged, ask the Authorised Service Centre for a copy so that the stove always has its own manual.
This symbol indicates the presence of an important message; failure to pay attention to it can result in
serious damage to the stove and even injury
Pay special attention to "words in bold face"
1.3 Safety rules.
Read the use and maintenance manual before installing, lighting and servicing the stove.
-
-
Installation, the electrical connection,testing and maintenance must be carried out by a qualified and/or authorised technician.
Connect the stove to an approved flue by means of an inspectionable terminal; several units can be connected only if allowed
-
by the local regulations and by the flue inspection Body.
-
Connect the stove to the suction system by means of a pipe or air inlet from outside.
Connect the stove to an approved 230 V-50 Hz electrical socket.
-
-
Make sure the electrical system and the sockets are suitable for the maximum absorption of the unit, specified on the label
and in this manual.
-
The stove must be unplugged and cold before carrying out any maintenance.
Do not use flammable liquids or substances to light the stove or rekindle the flame: when the stove is lit, pellet ignition is
-
automatic.
The pellet stove must only be fed with wood pellets having the characteristics described in this manual.
-
-
The stove must not be used as an incinerator.
-
Never block the combustion air inlet and fume outlet openings.
Do not handle easily flammable or explosive substances near the stove while it is operating.
-
-
Do not remove or modify the pellet hopper protection grille or the safety devices.
Do not operate the stove with the fire door open and/or the glass damaged or broken.
-
-
During operation the intense heat generated by combustion of the pellets makes the external surfaces of the stove very hot,
and in particular the fire door, handle and flue pipe. Therefore avoid contact with these parts without suitable protection.
-
Keep objects that are flammable and/or not heat resistant at a suitably safe distance.
Clean the brazier regularly every time the stove is lit or whenever reloading pellets.
-
Have the duct and smoke baffles inside the combustion chamber cleaned regularly by qualified personnel.
-
-
Avoid the creation of smoke and unburnt products during lighting and/or normal operation; an excessive accumulation of
unburnt pellets in the brazier must be eliminated manually before carrying out relighting.
-
Warn children and guests about the hazards described above.
The device can be used by children aged less than 8 years, and by people with reduced physical, sensory or mental
-
capabilities, or lack of experience or knowledge, provided under supervision or after the same has received instructions
relating to 'safe use of and understanding of the dangers inherent in it. children should not play with the appliance
In case of operating problems, the stove can be relit only after eliminating the cause of the problem.
-
-
Any tampering and/or unauthorised replacements with non-original parts of the stove can create a risk for the user's safety
and relieves the manufacturer of any civil or penal liability.
-
Only use original replacement parts recommended by the manufacturer.
The manufacturer declines any liability for problems, damage or accidents caused by failure to follow or apply the
instructions contained in this manual.
31
OMEGA PLUS