Starrett S7020 Manual De Instrucciones página 112

12. REDUCE the pressure when the Blade to reach the end of the cut;
13. ALLOW that the machine stops completly before to remove the Blade
of the material;
14. When the material is fiberglass, plaster or plastering, CLEAN the
machine motor openings often with a vacuum or compressed air. These
materials are highly abrasive and can accelerate wear of the bearings and
damage the motor.
WARNING: The cutting speeds should vary in according to the material.
Hard materials such as metals, require lower speeds, the softer materials,
CAUTION: KEEP MAXIMUM ATTENTION during the cutting process.
FIG 07
112 S7020
higher speeds.
Familiarity with the machine does not dispense the
necessary care.
Risk of accidents with serious injury and damage!
ENGLISH