Starrett S7020 Manual De Instrucciones página 115

DANGER: Plunge Cutting, ONLY for soft and thin materials,
CUTTING IN METALLIC SURFACE :
The Reciprocating Saw saw can be used on metal such as thin steel sheets,
pipes, rods of steel, aluminum, brass, and copper. TAKE careful not to twist
or bend the Saw Blade DO NOT the cut!
It is recommended to use coolant liquid for cutting soft and hard metals.
The coolant liquid will keep the cold the Blade, increase cutting action, and
prolong the life of it.
WARNING: NEVER USE fl ammable materials such as coolant
1. FIX fi rmly and safely the material to be cut in the position, and MAKE
the cut closest to the point of fastening in order to minimize vibration in the
material;
2. When cutting pipe or thick plate, fi x in a vise, if possible, cut close of
the point of fastening;
3. To cut the material of little thickness, fi xa between pieces of plywood
or hard paperboard, and fi x the layers together in order to reduce vibration
and rupture of the material that is been cut.
with penetration capacity such as plywood and
agglomerated wood and dry wall.NEVER USE in
plastic and sheet metal, hard and thick woods.
system or cutting lubricant, for possible sparks can
cause fi res.
Risks of accidents and burns!
ENGLISH
S7020 115