Instructions For Operation; Before Operation - Max HS130 Manual De Funcionamiento

Thinner
Gasoline
DO NOT OPERATE THE TOOL NEAR A FLAM-
MABLE SUBSTANCE
Never operate the tool near a flammable sub-
stance (e.g., thinner, gasoline, etc.). Volatile
fumes from these substances could be drawn
into the compressor and compressed together
with the air and this could result in an explosion.
DO NOT USE A WRONG FITTINGS
The connector on the tool must not hold pressure
when air supply is disconnected. If a wrong fitting
is used, the tool can remain charged with air after
disconnecting and thus will be able to drive a fas-
tener even after the air line is disconnected, pos-
sibly causing injury.
DISCONNECT THE AIR SUPPLY AND EMPTY
THE MAGAZINE WHEN THE TOOL IS NOT IN
USE
Always disconnect the air supply from the tool
and empty the magazine when operation has
been completed or suspended, when unattend-
ed, moving to a different work area, adjusting,
disassembling, or repairing the tool, and when
clearing a jammed fastener.
4. INSTRUCTIONS FOR OP-
ERATION
READ SECTION TITLED "SAFETY IN-
STRUCTIONS".

1. BEFORE OPERATION

Check the following prior operation.
1 Wear Safety Glasses or Goggles.
2 Do not connect the air supply.
3 Inspect screw tightness.
4 Check operation of the contact arm & trigger
if moving smoothly.
[AIR COMPRESSOR / AIR HOSE]
Air compressor
17 bar
250 psi
Used at 17 to 23 bar
(250 to 320 p.s.i.)
WHEN USING THE TOOL, BE SURE TO USE A
SPECIAL AIR COMPRESSOR AND AIR HOSE.
In order to improve its performance, it has set its
working pressure higher than the conventional
nailers. To use the tool, you always need the
special air compressor and air hose (MAX Pow-
erLite Compressor and MAX PowerLite Hose).
Use of high-pressure gas (for example, oxygen,
acetylene, etc.) causes abnormal combustion,
possibly resulting in explosion. Use only the spe-
cial air compressor and air hose.
NOTE:
Frequent, but not excessive, lubrication is re-
quired for the best performance. Oil added thru
the air line connection will lubricate the internal
parts.
5 Connect the air supply.
6 Check the air-leakage. (The Tool must not
have the air-leakage.)
7 Hold the Tool with finger-off the trigger, then
push the contact arm against the work-piece.
(The tool must not operate.)
8 Hold the Tool with contact arm free from
work-piece and pull the trigger. (The Tool
must not operate.)
9 Disconnect the air supply.
9
Air hose
23 bar
320 psi