BH FITNESS G6130 Instrucciones De Montaje Y Utilización página 18

9
Do not use the machine outdoors.
10
To unplug the machine, first put
the switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This safety
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should the
repeatedly then the most probable
causes are:
-Abnormal working conditions,
-Treadmill belt in need of lubricant,
-Solvent based lubricants used (use
BH type),
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
device will
circuit breaker
Fig.B
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box and place
it on the floor as shown in Fig.0.
Make sure that all of the pieces are
there:
(1) Main structure; (44) Side bar base
cover (Left); (45) Side bar base cover
be
(Right);
Combination box spanner; (24) Spanner
with star screwdriver; (142) Allen key
6mm; (69) Screw M-6x20; (87) Screw
M-5x16; (106) Safety key; (119) Bottle
of lubricant; (113) Mains
Follow the instructions step by step to
assemble:
1.- First loosen the two top holding
knobs (22) by two turns, anticlockwise,
trip
Fig.1, next take hold of the handrails
(9 and 10) and lift them in the direction
of the arrow, as shown in Fig.2, until
you hear the top holding knobs (22)
click into position.
2.- Now loosen off the bottom holding
knobs by two turns (22) Fig.3.
Holding the handrails (9 and 10), lift
the focus bars in the direction of the
arrow, see Fig.4, until you hear the
bottom holding knobs (22) click into
position.
NOTE: Make sure that you hear the
top holding knobs click into the
handrails and the bottom knobs click
into the focus bars before you let go of
the handrails.
3.- Once you have completed the
above, tighten the top knobs (22)
securely,
clockwise and the bottom knobs (22)
Fig.5, by turning it clockwise.
18
(46) Side supports;
cable.
Fig.5, by turning
(23)
them