Warranty Conditions; Safety Measures - Easymate Floor 300 Instrucciones De Uso

WARRANTY CONDITIONS:

The warranty does not cover: consumables (batteries, etc.) and damage caused by misuse, improper use, im-
proper installation, external intervention, damage due to physical or electrical shocks, dropping, or atmospheric
phenomena.
• Do not open the device, as this will void the warranty.
• If the unit is returned for After Sales Service, protect the caster to prevent scratches.
• Clean with a soft cloth only, no solvents. The guarantee is void if parts have been dismantled. Before cleaning it,
disconnect the equipment or switch it off at the mains.
Warning: Do not use any gasoline or carboxylic acid, alcohol or similar treatment. In addition to damaging
your device, the fumes are also hazardous to your health and are explosive.
Do not use any tool that can conduct voltage (wire brush or other sharp tool, etc.) for cleaning.
The till receipt or invoice is your proof of purchase date.

9. SAFETY MEASURES

Any damage caused by a failure to adhere to the manual shall void the warranty. We assume no liability for damag-
es resulting therefrom!
We cannot be held responsible for any damage to property or persons caused by incorrect use or a failure to
adhere to the safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to maintain this status
and get the most out of the product, users must adhere to the safety instructions and warnings contained in this
manual.
: This symbol indicates that there is a risk of electric shock or short-circuit.
- You should only use this product with a voltage between: 100-240 volts and 50-60 hertz. Never attempt to use
this device with a different voltage.
- Ensure that all the system's electrical connections conform to the instructions for use.
- In commercial establishments, ensure that you adhere to the electrical installation accident prevention
regulations.
- In schools, training facilities, workshops, etc. qualified personnel must be on hand to monitor electronic
equipment operation.
- You must follow the instructions for use of any other devices connected to the system.
- Please contact an experienced person if you have any doubts regarding equipment operation or safety.
- Never plug in or unplug electrical equipment with wet hands.
- When installing this product, check that the power supply cables are not at risk of being damaged.
- Never replace damaged electrical cables yourself! In this case, remove them and call an expert.
- The mains supply should be located close to the device and must be easily accessible.
WARNING
Alerts the user to the presence of "dangerous voltage", uninsulated inside the product's casing,
of sufficient magnitude to constitute a risk of electric shock to persons.
This product is guaranteed for parts and labour in our workshops.
Gives users important instructions regarding use and servicing (repair) contained in
the document which accompanies the equipment.
Easymate by Extel - FLOOR 300 - 07/2017
GB10