Speed Adjustment Control; Using The Machine; Preliminary Operations; Safety Checks - Alpina ABL 40 Li Manual De Instrucciones

Starting the machine causes the
simultaneous rotation of the rotor.
The machine stops automatically as
the throttle control is released.

5.2 SPEED ADJUSTMENT CONTROL

This control (Fig. 4.B) is used to adjust
the rotation speed of the impeller and
therefore regulate the air flow speed.
Speed can be increased or decreased by
turning the control and must be related
to the type of work (chap. 6.4.1).

6. USING THE MACHINE

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.

6.1 PRELIMINARY OPERATIONS

Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
6.1.1 Checking the battery
• Before each use:
– check the battery charge status following the
instructions provided in the battery booklet.

6.2 SAFETY CHECKS

Run the following safety checks and
ensure that the results correspond
to those outlined in the tables.
Always carry out the safety
checks before use.
6.2.1 General check
Object
Hand grips (Fig. 1.C.)
Screws on the machine
Cooling air ducts
Blower tube (Fig. 1.B)
Result
Are clean, dry and fixed
firmly to the machine
Correctly tightened
(not loose)
Not clogged
Correctly installed.
No signs of damage
No obstruction.
Rotor
Guards
Battery (Fig. 1.D.)
Machine
Throttle control (Fig. 4.A)
6.2.2 Machine operating test
Action
1. Fit the battery in its
housing (para. 7.2.3 ).
2. Press the throttle
control (Fig. 1.F).
1. Release the throttle
control (Fig. 4A).
Test driving
If any of the results fail to match
the indications provided in the tables
below, do not use the machine! Take
it to a service centre to be checked
and repaired if necessary.
6.3 START-UP
1. Adopt a firm and well-balanced position;
2. make sure that the blower tube is not
directed towards any bystanders or debris;
3. fit the battery inside its housing
correctly
(para. 7.2.3)
4. press the throttle control (Fig. 4.A).
6.4 OPERATION
While working, the machine
must always be held firmly with the
hand on the handgrip (Fig 5).
NOTE During use, the battery is
protected against total drainage with a
protective device that switches off the
machine and stops it from working.
6.4.1 Adjusting the speed
It is always advisable to set the
rotor speed in relation to the type of
material to be removed (Fig. 4.B):
EN - 9
No signs of damage
No signs of damage
No damage to the casing,
no liquid leakage
No signs of damage
or wear
It must move freely
and not be forced.
Result
The machine starts and
the rotor starts rotating.
1. The control should
return automatically
and quickly to the
neutral position and the
machine should stop.
No abnormal vibrations.
No abnormal sound
;