HSM shredstar X8 Instrucciones De Servicio página 9

5 Operation
Warning!
Before switching the machine on,
make sure that you observe all safety
instructions.
Switching the paper shredder on
• Set the sliding switch to "ON/AUTO"
for automatic mode.
ON OFF REV
AUTO The "Power" display lights up.
Note: You can increase the durability of your
shredder by removing staples and small paper-
clips from the paper.
• Feed the paper into the centre
of the paper slot, but never insert
more than 8 sheets at the same
time. When there is a paper jam,
the cutting unit switches to re-
verse and pushes the paper out
again.
 The light barrier starts the cutting unit auto-
matically. Therefore, with thin paper strips,
make sure the light barrier detects them.
 When the feed opening is clear of paper
again, the cutting device switches off.
Use the designated opening to
shred CDs and credit cards. Feed
the CDs in one by one.
• Empty the CD container at the latest after
shredding 10 CDs. To do this, unplug the
power plug and remove the cutting head.
The separate CD container is in the shred-
ded material container.
Note: You cannot use the two cutting units at
the same time. Destroy paper and CDs/credit
cards separately.
Swit ching paper shredder off
• Set the sliding switch to "OFF".
ON OFF REV
AUTO
06/2014
6 LED displays, troubleshooting
Power:
Appliance is ready for use
Sliding switch on ON/AUTO or REV
Overload:
Machine is overloaded. You have
fed in too much paper.
• Set the slider switch to "REV".
 Pa per is pus hed out.
ON OFF REV • Se pa ra te pa per stack.
AUTO
• Set the slider switch to "ON/
AUTO" again.
• Feed in pa per successively
Overheat:
The motor has overheated.
• Let the document shredder cool down for
60 min. You can restart the machine once the
display has gone out.
Shredded material container full
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Pull out the power plug.
• Move cutting head away.
• Empty cut material container.
• Remove cutting head.
Cutting unit runs continuously
- The light barrier in the paper feed is blocked
with paper. Press the paper through with a thin
strong piece of cardboard.
- The light barrier is soiled with paper dust.
Clean the sensor with air pressure, a dry
paintbrush or a cloth.
shredstar X8
english
9