Adjustment; Sliding Table Flatness Adjustment; Extension Table Flatness Adjustment; Rip Fence Precision Adjustment - LEMAN SST256 Manual De Instrucciones

5. ADJUSTMENT

WARNING
Handle the tools with protective gloves.
5.1 SLIDING TABLE FLATNESS
ADJUSTMENT
Tools Required for Assembly:
- Straight edge
- Feeler gauge
- L wrench 3mm
- Put the Straight edge A on the cast iron table B and
sliding table C, use feelder gauge to check the flatness.
- Rotate the handle D to micro-adjust the flatness.
5.2 EXTENSION TABLE FLATNESS
ADJUSTMENT
Tools Required for Assembly:
- Straight edge
- Feeler gauge
- L wrench 3mm
- Wrench 13mm
- Put the Straight edge A on the cast iron table B and
extension tables C, use feelder gauge to check the
flatness.
- Re-tighten the bolts D to micro-adjust the flatness.
5.3

RIP FENCE PRECISION ADJUSTMENT

Tools Required for Assembly:
- Straight edge, Angle gauge, Depth Gauge
- Feeler gauge
- Wrench 13mm
- Use Angle Gauge A and Feelder Gauge to check the
verticality between table and rip fence. Loose 4pcs shaft
B, and micro-adjust its position up and down to get better
verticality.
- Use Straight Edge and Depth Gauge to check the
parallel between blade and rip fence. Loose 4pcs shaft B,
and micro-adjust its postion forward and backward to get
better parallel.
D
A
C
GB
-13-
C
B
Fig.5.1
A
D
D
B
Fig.5.2
A
Fig.5.3
D
A
C
B