Usage (Blood Pressure); Attaching The Cuff - Beurer BM 93 Cardio Instrucciones De Uso

4. The alarm hour flashes on the display when the alarm has been activated. Set the alarm hour using
the +/− buttons. To confirm the alarm hour, press the memory button M.
5. The alarm minute now flashes on the display. Set the alarm minute using the +/− buttons. To con-
firm the alarm minute, press the memory button M.
6. " " appears on the display. To complete the operation, press the START/STOP button
The device then switches off.

7. Usage (blood pressure)

Before commencing blood pressure measurement, observe the "Notes on using the blood pressure
monitor" in chapter "2. Important notes".

7.1 Attaching the cuff

Place the cuff onto the bare upper arm. The circulation of the arm must not
be hindered by tight clothing or similar.
The cuff must be placed on the upper arm so that the bottom edge is posi-
tioned 2 – 3 cm above the elbow and over the artery. The line should point
to the centre of the palm.
Now tighten the free end of the cuff, but make sure that it is not too tight
around the arm and close the hook-and-loop fastener. The cuff should be
fastened so that two fingers can fit under the cuff.
Now insert the cuff line into the connection for the cuff connector.
44
.