Sears Kenmore 2800 010 Serie Manual De Uso página 6

0
START/PAUSE/UNLOCK LID
Press to start the selected cycle; press again to pause
the cycle and unlock the lid. Press and hold 3 sec to
cancei a cycle.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid.
O POWER
Pressto turn the washer on and off, or to cancel a cycle.
O
CYCLE STATUS LIGHTS iNDiCATOR
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
SENSING
Sensing
When the START/PAUSE/UNLOCK P
.....
h/Soak
LID button is pressed, the washer will
Wash
first perform a self-test on the lid lock
mechanism. You will hear a click, the Rinse
basket will make a slight turn, and the lid Spin
will unlock briefly before locking again. CycleComplete
Once the lid has locked the second time, LidLocked
the washer will use short, slow spins to
estimate the load size. These sensing spins may take 2 to
3 minutes before water is added to the load and you may
hear the hum of these spins. If the sensing light is on, then
washer is working properly. You will hear the motor turn
the basket in short pulses to thoroughly wet the load. The
washer will then move the load briefly, pause to allow
water to soak in to the load, and resume adding water.
This process may repeat until the correct amount of water
has been added for the load. You may also hear water
flowing through the dispenser r adding detergent to the
load.
NOTE: Avoid opening the lid during sensing. The sensing
process will start over when the washer is restarted. The
sensing light may also come on during the Prewash and
Wash portions of the cycle. This is normal.
PREWASH/SOAK
Use this option to add an extra agitation
and soak time to the beginning of any cycle
to break up tough stains.
Sensing
Prewash/Soak
Wash
Rinse
Spin
Cycle Complete
Lid Locked
WASH
Sensing
You will hear the motor and washpiate Prewosh/Sook
moving the load.
Wash
Unlike traditional washers, the load is not
covered with water. Low-water cleaning Rinse
means concentrated cleaning. Rather than Spin
diluting detergent as done in an agitator- CvdeComplete
style washer, this washer delivers the LidLocked
detergent directly to the soils. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
RINSE Sensing
You will hear sounds similar to the wash cycle Prewosh/Sook
as the washer rinses and moves the load. Fabric
Wash
softener will be added if the Fabric Softener
Rinse
option was selected. Some cycles use spray
rinsing. Spin
Cycle Complete
Lid Locked
SPIN Sensing
The washer spins the load at increasing speeds for Prewash/Soak
proper water removal, based on the selected cycle
and spin speed. Wash
Rinse
Spin
Cycle Complete
Lid Locked
CYCLE COMPLETE
Sensing
Once the cycle is complete, this light will come on. Prewash/Soak
Remove the load promptly for best results.
Wash
Rinse
Spin
Cycle Complete
Lid Locked
LID LOCKED Sensiog
To allow for proper load sensing and spinning, Prewash/Soak
the lid will loci< and the Lid Locked light will turn
Wash
on. This light indicates that the lid is locked and
cannot be opened. Rinse
If you need to open the lid, press START/PAUSE/ Spin
UNLOCK LID. The lid will unlock once the washer CvdeComplete
movement has stopped. This may take several
minutes if the load was spinning at high speed.
Press START/PAUSE/UNLOCK LID again to
resume the cycle.
You may also add or remove options for each
cycle. Not all options can be used with all cycles,
and some are preset to work with certain cycles.
Lid Locked
START/ uPAoUS,E
6