Medisana BOB Instrucciones De Manejo página 23

After you have chosen a program, press the On- / Increase intensity
NOTE
The device only starts the pulse emitting when proper contact of
the electrodes to the skin is present. If the device does not
detect proper contact, a long beep can be heard and the device
switches to the program select mode. Check for proper
attachment of the belt to your body.
The displayed time (program duration) will start to count down to 0.
You may experience a light formication during the usage. With in-
creasing intensity you will feel the contracting abdominal muscles,
which then will relax again after some seconds. At the end of the
program two beeps (one short and one longer beep) will be emitted
and the device will stop the pulse emission. You may also manually
stop the pulse emission by pressing & holding the Off- / Reduce inten-
sity
multuiple presses on the button until the intensity level is set to 1.
Another press on the button then leads to a stop of pulse emission.
3.3 During the use you may adjust the intensity with the
buttons in 25 levels. A decrease of the intensity is always possible by
Intensity
pressing the
setting
4
Press the
25). To avoid unintended increase of the intensity, the device will auto-
matically switch on the keylock function after approx. 5 seconds without
pressing any button. At this time, the display backlight will extinguish
and the keylock symbol
lock the key function, press
right away by 1 step (if the intensity is already at level 1, the unit will stop
the pulse emission). An increase of the intensity is only possible without
active keylock function.
Only adjust the intensity level as high as it still feels pleasant for you.
WARNING
If you feel uncomfortable during the use of the unit, adjust a
lower intensity. Is it still feeling uncomfortable or if the skin
is itching or aching, immediately stop the usage and consult
a doctor.
3
- button again to start the training.
- / Program button
4
- button. Is the lowest level (1) already set and the
- button is pressed again, the device will stop the pulse emission.
3
- button to increase the intensity by 1 setp (max. up to
3 Operating
4
until the device switches off or by
6
appears in the LC-display
4
. This also decreases the intensity
GB
G
3 4
- and -
1
. To un-
G
G
17