Functional Description - Dolmar AT-3623 Manual De Instrucciones

PARTS DESCRIPTIONS
AT-3623 / AT-3624
4
3
6
1 Battery cartridge
2 Indication lamp
3 Switch trigger
4 Hanger (suspension point)
5 Grip
6 Guard
011727

FUNCTIONAL DESCRIPTION

WARNING:
• Always be sure that the tool is switched off and battery
cartridge is removed before adjusting or checking the
functions on the tool. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
Installing or removing battery cartridge
CAUTION:
• Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may cause
them to slip off your hands and result in damage to the
tool and battery cartridge and a personal injury.
• Always switch off the tool before insertion or removal of
the battery cartridge. (Fig. 6)
To remove the battery cartridge, withdraw it from the tool
while sliding the button on the front of the cartridge.
12
1
2
10
7
8
AT-3630 / AT-3631
2
5
5
9
6
7 Gear case
8 Cutting tool
9 Shoulder harness
10 Buckle
11 Barrier
12 Guard extension
To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Always insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely. Insert
it fully until the red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to you or
someone around you.
NOTE:
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Power switch action
WARNING:
• Before inserting the battery cartridge in the tool,
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off button.
1
3
4
11
9
12
10
7
8