Operation; Preparations Before Starting; Check The Drilling Equipment; Blow Out The Air Hose - Atlas Copco RH 656W Instrucciones De Seguridad, Empleo Y Mantenimiento

RH 656W
1. Push the retainer outwards in the direction of the
arrow until the drill steel collar disengages from
the front of the retainer.
2. Pull the drill steel out.
3. Push back the retainer.

Operation

WARNING Involuntary start
Involuntary start of the machine may cause injury.
► Keep your hands away from the start and stop
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
© 2014 Atlas Copco Construction Tools AB | No. 9800 0657 71c | 2014-01-09
Original instructions
Safety and operating instructions

Preparations before starting

Check the drilling equipment

Check that all of the drilling equipment is in good
♦
condition.
Check that the impact surface of the drill steel
♦
shank is flat, with no signs of wear.
Make sure that the air inlet and exhaust ports are
♦
free from obstructions.
♦ Check that the flushing holes in the drill steel and
drill bit are not blocked, and that the flushing air
and water flows through without obstruction.
♦ Ensure that the fittings are tight and leak-proof.
DANGER Whipping air hose
A compressed air hose that comes loose can lash
around and cause personal injury or death
Check that the compressed air hose and the
►
connections are not damaged.
► Check that all compressed air connections are
properly attached.

Blow out the air hose

♦ Every day before using the drill, blow out the air
hose to clear it of accumulated dirt and moisture.

Fill the lubricator with oil

Check that the chuck and insertion tool shank are
♦
always covered with a film of oil.

Attaching the pusher leg to the rock drill

The pusher leg must be fixed to the rock drill by
means of the bayonet coupling.
17