Tabla de contenido
Publicidad
Important Safety Instructions
EN
Caution Statements
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Clean only with a dry cloth.
6. Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
7. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit the apparatus.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Only use attachments/accessories specified by the
manufacturer.
10. Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
11. Unplug this apparatus during lightning storms or when
unused for long periods of time.
12. Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, liquid has been spilled or objects have fallen into
the apparatus, does not operate normally or has been
dropped.
Safe operation
Power requirements for this product are 99-253V~ 50/60 Hz.
Should any liquid or object fall into the equipment, please
refer to qualified personnel for service.
Do not take the cover off the equipment without
disconnecting it from the mains.
Safe installation
Ambient temperature should not be higher than 113°F.
Do not place the equipment in a place where it can suffer
vibrations or shocks.
Please allow air circulation around the equipment.
Do not place naked flames, such as lighted candles on or
near the product.
Optical connection instructions:
An SC/APC single mode fiber cable must be used. Remove
the protective cover from the optical connector on the unit
and the cap on the cable connector.
Carefully align the guides on both connectors when
plugging a cable to the device, then push the connector all
the way in.
Take special care to avoid damaging the unprotected
ends of the connectors, as small scratches, impurities and/
or particles of dirt, oil, grease, sweat, etc. may significantly
affect the quality of the signal.
To clean the ends of the connectors, gently rub with a lint-
free lens cleaning cloth, dampened using additive-free
isopropyl alcohol. Make sure the alcohol evaporates fully
before connecting. Keep the connector covers and cable
caps in a safe place in case they are needed in the future.
Always fit the covers on the connectors of devices that are
not connected to cables to prevent the laser beam from
damaging the eyes.
Do not turn the transmitter on without a fiber optic cable
connected to it.
Safety measures
- The use of controls or adjustments, as well as different
procedures beyond those specified in this manual could
result in exposure to harmful radiation.
- Read and follow the instructions in this manual very carefully,
keep this manual for future reference.
- Do not use the equipment in a way that does not conform
to these operating instructions or under any condition that
exceeds the indicated environmental specifications.
- The user cannot service this equipment. For technical
assistance, contact our technical assistance department.
- The laser beam should not be pointed at people and/or
animals.
Symbology
This symbol indicates that the equipment complies
with the safety requirements for class II equipment.
Caution, risk of electrical
shock.
The equipment complies with the CE mark
requirements.
3
Publicidad
Tabla de contenido
