Power Supply; Intended Use - Makita 2704N Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Arbor hole
(Country specific)
Blade diameter
Max. cutting capacities
No load speed
Table size (L x W)
Dimensions (L x W x H) with
table(s) not extended
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
Do not place hand or fingers close to the
blade.
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The tool is intended for cutting in wood.
Straight cutting, bevel cutting, and miter cutting are
available with this tool. This tool is not designed for non-
through cutting.
bevel 0°
bevel 45°
with sub tables (R) and (back)
with sub table (R)
without sub table (back)
with sub tables (R) and (back)
with sub table (R)
without sub table (back)
1,045 mm x 1,066 mm (tables extended)
665 mm x 753 mm (tables stored)
567 mm x 1,066 mm (table extended)
567 mm x 753 mm (table stored)
715 mm x 753 mm x 483mm
665 mm x 753 mm x 483 mm

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
9 ENGLISH
2704N
30 mm / 25.4 mm
260 mm
93 mm
64 mm
-1
5,200 min
35.2 kg - 37.0 kg
/II
) : 94 dB(A)
pA
) : 107 dB (A)
WA