Intended Use; Power Supply - Makita M2300 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Blade body thickness
Hole diameter For all countries other than European countries
For European countries
No load speed
Dimensions (L x W x H)
Net weight
Safety class
Cutting capacities (H x W) with blade 255 mm in diameter
Bevel angle
0°
45° (left)
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
To loosen the bolt, turn it clockwise.
Miter angle
0°
75 mm x 130 mm
48 mm x 120 mm

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
WARNING:
8 ENGLISH
M2300
255 mm
1.6 mm - 2.4 mm
25.4 mm
30 mm
-1
4,200 min
610 mm x 485 mm x 515 mm
14.7 kg
/II
45° (left and right)
75 mm x 90 mm
48 mm x 90 mm
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
) : 92 dB(A)
pA
) : 105 dB (A)
WA
Wear ear protection.