PR2000, PR2500
Retracting the hand crank version
➤ Click the top end of the hand crank into the holder in the awning.
➤ Turn the hand crank until the awning is extended by only about 1.5 metres.
Position the struts vertically and back under the front panel every 30 cm so that
the awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the front panel.
➤ Slide the bottom part of the right strut into the latch of the front panel.
➤ Retract the other strut in the same way.
➤ Turn the hand crank until the awning is fully retracted.
➤ Double-check that the awning is fully retracted before starting your journey.
The front panel should be right up against the housing.
➤ Remove the hand crank from the holder on the awning.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
Retracting the motor version
➤ Press the button
extended by about 1.5 metres. Position the struts vertically and back under the
front panel every 30 cm so that the awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the front panel.
➤ Slide the bottom part of the right strut into the latch of the front panel.
➤ Retract the other strut in the same way.
➤ Press the button
completely retracted.
EN
of the switch or the remote control until the awning is only
of the switch or the remote control until the awning has been
Operating the awning
21