Tightening The Screws On The Hinges; Patching Small Holes In The Fabric - Dometic PERFECTROOF PR 2000 Instrucciones De Uso

Cleaning and maintenance
➤ Check the awning regularly:
– Is the fabric free of damage?
– Are the arms and front panel free of damage with no signs of wear?
– Does the awning close properly?
8.4

Tightening the screws on the hinges

The screws on the hinges must be tightened up after being used for the first time:
• after the first holiday using the awning
• after driving 20000 km or six months after the awning was mounted
(whichever occurs first)
The screws on the hinge also need to be checked during the routine vehicle
inspection.
Contact your service partner to tighten up the screws.
Instructions for servicing (fig. i, page 11)
A
NOTICE!
The awning arms must not bear any load. This is to prevent the fastening
torque of the screws from being distorted.
➤ Lift up the front panel slightly so that the hinge does not bear any load.
➤ Tighten the screws with 15 – 25 Nm.
8.5

Patching small holes in the fabric

You can patch any small holes in the fabric or parts where the coating has come off:
➤ Use a cotton cloth to rub around the damaged area with a small amount of liquid
vinyl plaster (ref. no. 9103104018, available from your service partner).
✓ The liquid vinyl plaster dissolves the coating. The coating seals the hole when it
dries.
➤ Wait until the area is dry before you retract the awning again.
24
PR2000, PR2500
EN