Adjusting The Motor Version; Replacing The Batteries Of The Remote Control And The Wall Switch (Accessory) - Dometic PERFECTROOF PR 2000 Instrucciones De Uso

Ocultar thumbs Ver también para PERFECTROOF PR 2000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
Operating the awning
➤ Double-check that the awning is fully retracted before starting your journey. The
front panel should be right up against the housing.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
7.4

Adjusting the motor version

I
NOTE
The motor is pre-assembled in the roller tube.
If the awning no longer fully closes or opens, adjust the motor (fig. d, page 9 to
fig. g, page 10).
7.5
Replacing the batteries of the remote control and the
wall switch (accessory)
I
NOTE
If the LED of the remote control does not light up after pressing one of
the buttons, the remote control battery is flat.
➤ Open the housing (fig. h 1, page 11).
➤ Remove the old battery from the holder.
➤ Insert a new battery (type CR2450 for remote control, type CR2430 for wall
switch, fig. h 2, page 11) into the holder with the positive terminal facing
upwards.
➤ Reassemble the remote control or wall switch.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
22
PR2000, PR2500
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Perfectroof pr 2500Perfectroof pr2000

Tabla de contenido