Stadler Form Peter Manual De Instrucciones página 6

• Assemble the appliance in accordance with the instructions for Assembly.
Follow the instructions for assembly exactly and ensure that all screws
are firmly tightened so as to avoid damage and hazards.
• Never insert objects into the grille of the fan. Do not cover the appliance
during operation.
• Always disconnect the power cord from the socket before removing the
protection grille.
• Only connect the cable to alternating current. Observe the voltage infor-
mation given on the appliance.
• Do not use damaged extension cords.
• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
Assembly (see page 2 and 3)
Attach the foot (1) to the bottom of the housing (2) with the 4 screws pro-
vided. Make sure the screws are firmly tightened.
Setting up / operation
1. Place Peter in the desired location on a flat surface. Connect the mains
cable (3) to a suitable power outlet.
2. Switch on the appliance by pressing the on/off button (4). The blue LEDs
on the control panel (5) will then turn on. The appliance gives an audible
signal when a setting is changed via the control panel (5) or the remote
control (11).
3. Press the button for the selection of the speed level (6) to change the
fan speed (levels 1–3). Pressing once increases the speed by one level.
If you would like to increase the speed by another level, press again. The
number of the selected speed level (7) lights up on the front of the unit,
and disappears after 5 seconds.