Table; Boring Depth - HOLZMANN MASCHINEN SB 2516H Manual De Instrucciones

Taladro de columna
Ocultar thumbs Ver también para SB 2516H:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45

13.3.2 Table

Loosen clamp bolt (12). Now you can adjust the table in
height by turning the handle (13). Fix the table with clamp
bolt (12) in the chosen position.
To tilt of the operating table, loosen the screw (hexagon or
quick release on the bottom of the table) and adjust by
using the angle scale on the desired inclination. Fix it again
in the selected position.

13.3.3 Boring depth

For example:
Clamp a drill into the drill chuck.
Loosen the depth scale.
Now put the workpiece onto the table, turn the table upwards until the drill touches the
workpiece.
Adjust the depth scale to zero.
Now turn the handle, until the scale reaches indicates the boring depth required. Bring the
drill back into upper position
Now tighten it.
The boring depth is now limited to the depth chosen.
You can adjust the depth also with an own method.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
OPERATION
42
SB 2516H

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido