Pentair Flotec EVO-MULTIPRESS 340 SX LOGIC SAFE Manual De Uso página 18

EN
USE AND MAINTENANCE MANUAL
SAFETY-CONSCIOUS WORKING
The safety instructions in this instruction manual, the existing national regulations regarding accident prevention,
and any internal working, operating and safety regulations must be adhered to.
SAFETY INSTRUCTIONS FOR THE OPERATOR/USER
All legal regulations, local directives and safety regulations must be adhered to.
The possibility of danger due to electrical energy must be prevented.
Legal regulations must be observed.
SAFETY INSTRUCTIONS FOR INSTALLATION, INSPECTION AND MAINTENANCE WORKS
As a basic principle, works may only be carried out to the equipment when it is shut down. Pumps or plant that
convey harmful substances must be decontaminated.
All safety and protection components must be re-fitted and/or made operational immediately after the works have
been completed. Their effectiveness must be checked before restarting, taking into account the current regulations
and stipulations.
UNAUTHORISED MODIFICATIONS, MANUFACTURE OF SPARE PARTS
The equipment may only be modified or altered in agreement with the manufacturer. The use of original spare parts
and accessories approved by the manufacturer is important for safety reasons. The use of other parts can result in
liability for consequential damage being rescinded.
UNAUTHORISED OPERATING METHODS
The operational safety of the supplied equipment is only guaranteed if the equipment is used for its intended
purpose. The limiting values given in the "Technical Data" section may not be exceeded under any circumstances.
INSTRUCTIONS REGARDING ACCIDENT PREVENTION
Never work alone. Always wear a hard hat, safety glasses and safety shoes and, if necessary, a suitable safety belt.
Before carrying out welding works or using electrical devices, check to ensure there is no danger of explosion.
For the sake of your health, be sure to pay meticulous attention to cleanliness wherever you are working.
Make sure that there are no toxic gases in the working area.
Observe the relevant occupational health and safety regulations and keep first aid materials available.
In some cases, the pump and the pumping medium may be hot and could cause burns.
For installations in areas subject to explosion hazards, special regulations apply!
This appliance can be used by children aged 8 years or over and by persons with limited physical, sensory or
intellectual capabilities, or with limited experience and knowledge, provided that they are supervised or have been
instructed in the safe use of the appliance and are aware of the dangers involved. Children must not be allowed
to play with the appliance. Cleaning and user maintenance must not be carried out by children unless they are
supervised.
DANGER - ELECTRIC SHOCK RISK
The pump must only be connected to sockets that have been installed properly in accordance with the
regulations and are protected with a FI-safety switch (RCD,30mA)
DANGER - ELECTRIC SHOCK RISK
Only qualified electricians may carry out electrical works to the pump or the controls.
DANGER - ELECTRIC SHOCK RISK
Always pull out the mains plug before carrying out any work on the pump.
DANGER - ELECTRIC SHOCK RISK
Check the rubber hose for mechanical or chemical damage. A damaged or kinked hose must be replaced.
16