Main Components; Assembly Components; Fitting The Hedge Trimmer Device - GGP ITALY MH 24 Li Manual De Instrucciones

4. Year of manufacture
5. Type of machine
6. Serial number
7. Name and address of Manufacturer
8. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorised service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (fig.1 ):
A. Motor: supplies the drive power
to the cutting means.
B. Comands rod: is fitted with
the main switch controls..
C. Rear handgrip: support handgrip located
on the rear of comands pole. This should
be grasped using the right hand.
D. Front handgrip: support handgrip
located on the rod commands. This
should be grasped using the left hand.
E. Hedge trimmer device:. device designed to
cutting and trimming of bushes and hedges
.Is supplied already mounted on the pole.
F. Harness: cloth belt that passes over
the shoulder, helps support the weight
of the machine while working. May only
be used with the extension pole
G. Blade (cutting means): the element
designed to cut the vegetation.
H. Extension tube: element that allows to
increase the length of the
I. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
J. Battery (if it is not supplied with the machine,
see chapter 15 "Attachments on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
K. Battery charger (if it is not supplied with
the machine, see chapter 15 "Attachments
on request"): device used to recharge the
battery; its specifications and directions for
use are described in a specific manual.
machine.
EN - 5
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 FITTING THE HEDGE
TRIMMER DEVICE
Perform all operations after
removing the battery.
The hedge trimmer device (Fig. 3.A) can be
mounted directly on 'commands rod (Fig.
3.B) so as to achieve the standard length.
• Insert the commands rod (Fig. 3.B) in the
auction device hedge trimmer (Fig. 3.A).
• Slide the collar (Fig. 3.C) upwards and turn
it clockwise until it is completely tightened.
Periodically check the connections to
ensure that they are tightened securely.