GGP ITALY MH 24 Li Manual De Instrucciones página 121

14. TROUBLESHOOTING
PROBLEM
1. The motor shuts
down whilst working
2. With the throttle lock
button and throttle
control lever on,
the cutting means
does not turn
3. The cutting means
overheats whilst working
4. The cutting means
comes into contact with
a line or electric cable
5. The cutting means
comes into contact
with a foreign body.
6. Excessive noise and/or
vibration is experienced
whilst working
7. The machine gives off
smoke whilst working
8. Battery power
reserve is low
9. The battery charger
is not recharging
the battery
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
The machine is damaged
The machine is damaged
Insufficient blade lubrication
-
-
Loose or damaged parts
The machine is damaged
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Make sure that the battery is
inserted correctly (par. 7.2.3)
Do not use the machine Remove the
battery and contact a Service Centre.
Do not use the machine. Immediately turn
off the machine
Contact a Service Centre.
Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (par. 7.4)
DO NOT TOUCH THE BLADE AS IT
MAY BE LIVE AND BE EXTREMELY
DANGEROUS! Grasp the machine using
the insulated rear handgrip only and
position it at a safe distance from yourself.
Disconnect the current that powers the
severed line or mains cable and remove
the battery before freeing the blade
Turn off the machine, remove the battery and:
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Turn off the machine,
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Do not use the machine. Immediately turn
off the machine
Contact a Authorised Service Centre.
Optimise operations
(par. 7.2.1)
Use a second battery or extended
battery (par. 15.1)
Purchase a new battery
Check it is correctly inserted (par. 7.2.2)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
EN - 12
SOLUTION
remove the battery and
teeth.
remove the battery and:
remove the battery and