Cleaning The Machine; Cleaning And Lubrication Of The Cutting Means; Nuts And Bolts; Occasional Maintenance - GGP ITALY MH 24 Li Manual De Instrucciones

• use the most appropriate technique
for the work to be performed
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• purchase a second standard battery
to immediately replace the discharged
battery, without compromising
the continuity of operations;
• purchase a battery with an extended
power reserve compared to the
standard version (par. 15.1).
7.2.2 Battery removal and recharging
1. Press the retainer tab in the
battery (Fig. 10.B) and remove it
from its housing (Fig. 10.A);
2. fit the battery (Fig. 11.A) in the battery
charger housing (Fig. 11.B);
3. connect the battery charger (Fig. 12.B)
to a power socket with the voltage
indicated on the rating plate.
4. fully charge the battery according
to the instructions in the battery/
battery charger booklet.
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 12.A) from the
housing in the battery charger (do not keep
recharging when recharging is completed);
2. disconnect the battery charger
(Fig. 12.B) from the mains;
3. fit the battery (Fig. 10.A) in its housing
pressing down until you hear it click firmly into
position which ensures the electrical contact;

7.3 CLEANING THE MACHINE

After every work session, clean the machine
thoroughly to remove all dust and debris.
• To reduce fire hazards, keep the machine
and, in particular, the motor free of
leaves, branches or excessive grease.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or handgrips.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
• To avoid overheating and damage to the
motor or the battery, always keep the
cooling air vents clean and free of debris.
7.4 CLEANING AND LUBRICATION
OF THE CUTTING MEANS
To increase the efficiency and working life
of the blades, clean and lubricate them
carefully after each work session:
Do not touch the cutting means until
the battery has been removed and the
cutting means is completely stationary.
• Place the machine in a stable
horizontal position on the ground.
• Use a soft cloth to clean the blades, along with
a brush to remove more difficult dirt and debris.
• Lubricate the blades by applying a light layer
of specific oil, preferably the non-pollutant
type, along the upper edge of the blade.

7.5 NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.

8. OCCASIONAL MAINTENANCE

8.1 CUTTING MEANS OCCASIONAL
MAINTENANCE
Do not touch the cutting means until
the battery has been removed and the
cutting means is completely stationary.
If the blades are used correctly, following all the
instructions provided, they will not require any
maintenance work and will not need sharpening.
EN - 9