Página 2
Please pass these instructions on to the end user of the fitting! S.v.p remettre cette instruction à l'utilisateur de la robinetterie! Entregue estas instrucciones al usario final de la grifería!
Página 5
English Installation 7. Slide the escutcheon (J) over the cap (H) and tighten with screws (J1), see Fig. [4]. 1. Remove the two screws (A1) from the fitting template (A), Do not use excessive force to tighten the screws. then remove the template, see Fig. [1]. 2.
Página 7
English Maximum hot water limit setting 5. Align the white mark (D1) on the limit stop against the number (1 to 10, see Fig. [6]) you have selected on the dial The adjustable hot water limit stop (D) is factory set in a and slide the limit stop (D), see Fig.
Página 9
English Maintenance 8. Pull the pressure balancing cartridge (P) out of the valve Check, clean and if necessary, replace parts. Grease with body noting the location of "H" and "C", see Fig. [13]. special valve grease. 9. Remove the check valve inserts (R), see Fig. [14]. If the check valves are removed it is important to reinstall them Pressure balancing cartridge, see Figs.