Important Safety Instructions - Master Appliance PROHEAT Quick-Touch 1000 Manual De Instrucciones

Important Safety Instructions

Heat guns are a source of extremely high-tempera-
ture flameless heat (up to 1050˚F / 566˚C). Extreme
caution should be observed when using these
products. READ and FOLLOW these instructions.
Use only on properly-rated electrical
circuits.
Connect to properly grounded outlets
only.
Disconnect from power source during
115V/15A or 230V/8A
service and when replacing parts.
To reduce risk of fire or electric
shock, do not expose heat gun to
rain or moisture.
Store indoors.
Do not use near flammable materials
or where fumes, gases or dust are
present.
Do not use in presence of explosive
atmosphere.
Keep nozzle at least 1"/2.5 cm from
work surface.
Do not apply to the same place for a
long time.
Be aware that heat may be conducted
to combustible materials that are out
of sight.
Use in well-ventilated area.
Use caution in confined areas.
Do not leave heat gun unattended
when it is switched on.
Always hold gun or place on its stand
(see below) when in use.
Place heat gun on its stand (built-in
or external) after use and allow it to
cool down before storage.
4
When using an extension cord,
use only a 3-prong grounded cord
rated equal to or greater than the
appliance.
Connect to properly grounded outlets
115V/15A or 230V/8A
only.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
Keep away from children and persons
with reduced physical, sensory
or mental capabilities or lack of
experience or knowledge.
Do not direct air stream at people
or pets.
Wear safety glasses at all times.
Do not touch nozzle until cool.
Recycle properly.
WARNING: This product, when used for
soldering and similar applications, can expose
you to LEAD, which is known to the State of
California to cause cancer and birth defects
and other reproductive harm. For more
information go to www.P65Warnings.ca.gov
www.masterappliance.com