Operating The Receiver; Main Menu; Installation; Manual Scanning - Samsung DTB-D700F Instrucciones De Uso

BASIC FUNCTIONS (DTT)
8. Teletext OSD
When the current broadcasting program provides Teletext OSD,
press the TEXT key twice to see the current Teletext OSD list.
To change the Teletext OSD:
Use the / keys to select a Teletext OSD you want.
Press the OK key and then the Teletext OSD you want is
displayed on the screen.
9. Teletext VBI
When the current broadcasting program provides
Teletext VBI, press the TEXT key three times to see the
current Teletext VBI list.
To change the Teletext VBI:
Use the / keys to select a Teletext VBI you want.
Press the OK key and then the Teletext VBI you want is
displayed on the screen.
N N o o t t e e : A television with TV functions supported shall be used.
The system shall operate with the subtitle turned off.
10. Audio Mode
You can choose a mode among left, right or stereo using the
AUDIO key.
To change the audio mode:
Press the AUDIO key to select the left, right or stereo.
Press the EXIT key to save and escape from this menu.
GB-20
D T T R E C E I V E R /

2. OPERATING THE RECEIVER

Main Menu

After installing your antenna system and DTB-D700F with appropriate connectors.
Plug in the AC main power and switch on the receiver.
Press the MENU key to bring up the main menu.
The following on screen display will appear:
The sub menu topics will be displayed.
For the sub-menus Installation, Channel Organising and
Parental Lock you need the PIN Code.

2.1. Installation

This menu consists of 3 sub-menus:
Manual Scanning, Auto Scanning and Reset to Factory Default.
Select "Installation" in the main menu mode to
select the sub menu.
Enter the PIN Code.
If you have not entered your own PIN Code then the
PIN Code 0000 applies, which was set at the factory.

2.1.1 Manual Scanning

To tune-in new channels and weak signals, the DTB-D700F has
been provided with the option "Manual Scanning" where the
channel data can be entered by the user.
After selecting the "Manual Scanning" from the Installation
Menu, the following screen will be displayed:
Select the channel which you want to find.
Input the frequency of the channel you want to find.
Select the bandwidth.
You can select the value of 6, 7 or 8 MHz.
Select the FFT (Fast Fourier Transform) Mode.
You can select the value of 2K or 8K.
After select option, press the OK key to start the
scanning process.
D V D P L A Y E R
GB-21