Remote Control - Yamaha Piano Craft MCR-E810 Manual De Instrucciones

Controls and Functions

Remote control

DVD/CD
• Playback
• Subtitle and
audio language
selection, etc.
DVD/CD mode
STANDBY/ON
1
5
9
DVD/CD
DVD/CD
TAPE/MD
SUBTITLE ANGLE
Common
functions
1
STANDBY/ON
2
1
5
9
TV CH
TV INPUT
ON SCREEN
INFO.
A-E
SET UP
TV VOL
3
4
DVD/CD
TAPE/MD
SUBTITLE ANGLE
8
En
TUNER
• Radio station
tuning
• Radio station
preset, etc.
TUNER mode
POWER
TV
2 3 4
6 7 8
SCAN DIMMER
0
SLEEP
TUNER BAND
TUNER
AUX/TV DOCK
ZOOM AUDIO
POWER
TV
2 3 4
6 7 8
SCAN DIMMER
5
0
REPEAT A-B
FREQ/TEXT
PROG
PTY SEEK
MODE START
SHUFFLE
MENU
PRESET
ENTER A-E
TOP MENU
/RETURN
VOLUME
DISPLAY
6
SLEEP
TUNER BAND
7
AUX/TV DOCK
ZOOM AUDIO
This remote control has two main operation modes to
control this system. Before operating functions in each
mode, you need to select a mode to change the remote
control key assignments.
To switch the operation mode
• DVD/CD mode: Press DVD/CD.
• TUNER mode: Press TUNER.
y
You can also operate the TV and other components (such as an
iPod) connected to the receiver using the remote control. For
details, see "Controlling External Components" on page 46.
Note
Remote control descriptions and illustrations in this manual are
based on the U.K. and Europe models unless otherwise specified.
Operations common to all modes
The following operations are available for the receiver
when the remote control is in any operation modes.
1 Infrared signal transmitter
Sends signals to the component you want to control.
2 STANDBY/ON (
Turns the receiver on or sets it to the standby mode (see
page 19).
3 DISPLAY
Switches the information shown in the front panel display
(see page 23).
4 SLEEP
Sets the sleep timer on the receiver (see page 44).
5 DIMMER
Changes the brightness of the receiver's front panel
display (see page 23).
6 VOLUME +/–
Adjusts the overall volume level on the receiver.
7 Input selection keys
Select the input source on the receiver.
y
STANDBY/ON, DIMMER and SLEEP operations also control
the DVD player when the DVD player is connected to the
receiver with the supplied system control cable (see page 12).
)