Remote Control - Yamaha Piano Craft MCR-E810 Manual De Instrucciones

Troubleshooting
Problem
Disc playback does
not start.
Picture freezes
momentarily during
playback.
The DVD player does
not read CDs and
DVDs.
Unable to turn on or
off a progressive scan
No sound during DivX
movie playback

Remote control

Problem
The remote control
does not work nor
function properly.
62
En
Cause
You may use a CD-R/RW, DVD+R/RW
or DVD-R/RW that is not finalized.
The disc label may not be facing up.
The disc may be defective.
JPEG or MP3/ WMA disc may not
contain sufficient picture files or music
tracks to be played back.
For MP3/WMA files, the sampling rate
and bit rate may not be compatible.
For JPEG files, the resolution may not be
compatible.
The region code of the disc may not be
supported with the DVD player.
The disc may be dirty.
The disc lens may be dirty.
The component video signal output setting
may not match the video connection.
The audio code may not be supported with
the DVD player.
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The remote control code is not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Remedy
Finalize the CD-R/RW, DVD+R/RW or DVD-R/RW.
Check that the disc label is facing up.
Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
Check that your JPEG or MP3/ WMA disc contains at
least 10 JPEG picture files or 5 MP3/WMA music
files.
For MP3/WMA files, check that the sampling rate
and bit rate are compatible. For JPEG files, check that
the resolution is compatible.
Check the region code.
Check the disc for fingerprints/scratches and clean it
with a soft cloth wiping from center to edge.
Use a lens cleaner to clean the lens.
Set "COMPONENT" of the DVD player to match the
connection method.
Remedy
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this system.
Replace all batteries.
Set the remote control code correctly using "LIST OF
REMOTE CONTROL CODES" at the end of this
manual.
Try setting another code for the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
See
page
—
—
—
—
63
63
64
64
54
See
page
11
—
11
48
48