Peg-Perego aria shopper twin Instrucciones De Uso página 14

EN_English
WARNING
_ IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these instructions
are not followed.
_ This item was designed for the transport of 2 children
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This item is approved for children from 6 months up to
a weight of 15 kg in the seat.
_ This seat in not suitable for children under 6 months
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
Check that the Peg Perego Ganciomatic product are
correctly fixed to the item.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always use
the five point harness. Always use the harness crotch
strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support the
child's weight. It is not designed to keep the child in
the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight in
the cup holder (if present) in excess of those indicated
on the cup holders themselves and never hot drinks.
Do not put loads of more than 0.2 Kg in the hood
pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present) on a
product without a hood or parasol that can hold it.
Always use the rain cover only under adult supervision.
Don't use the rain cover indoors and check to ensure
the child is not to warm; do not park the vehicle close
to heat sources and keep well away from the lighted
cigarettes. Ensure that the rain cover is not interfering
with any moving parts of the carriage/stroller. Always
remove the rain cover before folding your carriage/
stroller.
_ WARNING: This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
_ Do not use accessories which are not approved by the
manufacturer.
INSTRUCTIONS
1 OPENING: to open the stroller, simultaneously release
the two fasteners (fig_a) and firmly lift the handlebar
(fig_b), before pushing it down until the final click
(fig_c).
2 FITTING THE FRONT WHEELS: To mount the front
wheels, lower the lever (fig_a) and click the wheels into
place (fig_b).
3 BASKET: slide the basket under the seat in the direction
as shown and slip the front loops over the two hooks
on the frame (arrow 1). Slip the basket's slits over
support tube (arrows 2 and 3) and fasten the four
buttons at the back and the two on the side (arrow
4). Finally fasten the two loops at the side onto the
buttons on the frame (arrow 5).
4 FRONT BAR: insert the front bars in the corresponding
right and left hand positions (fig_a). The front bars
are independent in order to respond to each child's
different needs, and it is actually possible to open one
at a time or even remove one if preferred. To open the
front bar on one side only, press the middle button
(arrow 1) and rotate the front bar outwards (fig_b). To
remove the front bar, press both button (arrows 1 and
2) and remove the front bar.
5 HOODS: the hoods are independent. One or both may
be lowered at any one time. to apply the hoods, place
the attachments in their seats (matching left and
right) until they click.
6 Button the hoods to the back of the back rest (fig_a)
and open them pulling them completely forward
(fig_b).
7 BRAKE: Press down on the brake lever situated on the
rear wheel unit to set the brake on the stroller. Lift the
lever to release the brake. Always set the brake when
the stroller is at a standstill.
8 FIVE POINT SAFETY HARNESS: To fasten it, push the
two waist strap buckles (with the shoulder straps
attached – arrow_a) into the leg divider until they click
into place (arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c) and pull
the waist straps out (arrow_d).
9 To tighten the waist strap, pull on both sides in the
direction of the arrow (arrow_a). To loosen it, move it
in the opposite direction.
10 To adjust the height, slip the belts through the eyelet
in the fabric and position them in the most suitable
eyelet.
11 ADJUSTING THE BACKREST: to lower the backrest press
the clip (fig_a) and the backrest will move down to the
desired position.
To raise the backrest, press the clip and lift the backrest
to the desired height (fig_b).
12 SWIVEL WHEELS: to make the front wheels swivel,
lower the lever (fig_a). To fix them in place, lift the lever
(fig_b).
13 WHEEL REMOVAL: the stroller wheels may be removed.
To remove the front wheels, turn them to swivel
position, push the levers (fig_a) and simultaneously
push the wheel downwards until it is released (fig_b).
14 FOLDING: before folding the stroller, close the hoods
(fig_a). To fold the stroller, lift the buttons on the sides
of the handlebar (fig_b) and rotate the handlebar
forward until it clicks.
15 Push the backrest and the hoods towards the stroller
(fig_a) and lower the handlebar until it slots into its
housing (fig_b). Ensure the stroller is fully folded by
checking the safety fastener (fig_c). The stroller is
freestanding when folded up.
16 TRANSPORT: thanks to the carrying handle,
transporting the folded stroller is very simple.
17 To remove the hoods, push the side buttons and
simultaneously slip the hood upwards (fig_d).
18 REMOVABLE LINING: to remove the stroller lining, first
remove the hoods, then the cover on the side (fig_a).
Push the pin upwards and then outwards (fig_b), and
finally slip it out of the eyelet in the sack (fig_c). Do this
on both sides and in the middle.
- 14 -