Operating Instructions - Trotec BO20 Manual De Instrucciones

AL
AK

06. OPeratING INstructIONs

Powering the system on and off
• On/off key: Press the on/off key 5 to power up
the device.
• Press key 5 again to power off.
Recharging battery via USB port 8
• The system starts up automatically and starts the
charging cycle even when the unit is switched off.
The status message "Stand-by mode"appears on
the display.
Press the Plus 4 or the Minus 3, key to move the
cursor to the desired setting and the Mode key to
confirm the setting.
B - 4
1. Select "Yes"The switched off unit will only
has been connected to the USB charging unit.
2. If you select"No", the videoscope will start in
ging unit via the USB cable. This mode enables
• The symbol „
corner of the display when the battery voltage is
higher than 4.0V . The symbol „
1
pears in the same place when the battery voltage
is lower than 4.0V. This symbol indicates that the
charging cycle has started. The unit cannot be po-
STAND - BY - MODUS?
Operating manual – Mini-Videoscope
consume a minimal amount of power once it
This setting conserves battery power. The LEDs
remain in normal mode intensity throughout the
charging cycle.
normal mode. The videoscope can be operated
normally despite being connected to the char-
you to carry on working although the recharge-
able batteries are empty.
" appears in the top right-hand
STAND - BY - MODUS?
".ap-
-
G