Using The Device - Clatronic AKS 832 Instrucciones De Servicio

Using the device

Battery operation
• Disconnect the device from the mains adapter.
• Use the multi-function switch to turn the device on (I) or off
(O).
12 V power supply
Irrespective of the charging level of the battery, you may use
the device at any time with 12 V power supply.
NOTE:
Check the maximum current output of the on-board power
socket. It should use a 6 A fuse.
1. Turn off the device (switch position: O). If necessary,
disconnect the device from the mains adapter.
2. Press the button to open the cable storage compartment.
Extract the cable.
3. Close the cable storage compartment. Pay attention to the
cable guide in the cover.
4. Connect the connection cable to a 12 V on-board voltage
socket. The control indicator of the plug lights up, once the
power supply is connected. If necessary, turn on the igni-
tion of your car.
5. Use the multi-function switch to turn the device on (II) or off
(O).
Vacuuming dry dirt
NOTE:
We recommend using only a dry container and filter for
vacuuming dry dirt.
WARNING:
• Always disconnect the appliance from the mains adapter before
cleaning!
• If necessary, disconnect the device from the 12 V connection cable
before cleaning.
• Under no circumstances should you immerse the motor housing in
water in order to clean it. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Attach one of the two crevice nozzles (8/9). On top of that,
you can also attach the brush tool.
Vacuuming wet dirt or liquids
NOTE:
Observe the MAX marking on the container. Maximum
vacuuming capacity: 150 ml.
• Empty the collection container before vacuuming liquids or
wet dirt.
• Fit the attachment for wet vacuuming (13) or one of the two
crevice nozzles (8/9).
• In order to remove the nozzle, hold the end of the nozzle
down to avoid accidental leakage of the liquid.
Emptying the collection container
1. Turn off the device (switch position: O).
2. Keep the device horizontal when opening the collection
container.
3. Press the button (1) to unlock the collection container.
4. First pull the permanent filter from the collection container
and then remove the filter cover.
5. Empty the components.
6. Reinstall the components into the collection container in
reverse order.
7. Attaching the collection container to the housing: First posi-
tion the collection container at the bottom of the housing.
Then lock it at the button (1) on the top.
Cleaning
CAUTION:
• The single components are not dishwasher-safe.
• Wipe the casing with a damp cloth.
29