Kenwood KTC-V500E Manual De Instrucciones página 4

Installation
Connection
• Make sure to ground the unit to a negative 12V DC power supply.
• If your car's ignition does not come with an ACC position, connect the ignition wires
to a power source that can be turned on and off with the ignition key. If you connect
the ignition wire to a power source that receives a constant voltage supply, as with
battery wires, the battery may die.
• If the fuse blows, first make sure that the wires have not caused a short circuit, then
replace the old fuse with one with the same rating.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the
car are working properly.
Ignition key switch
+ –
Battery
4
Downloaded from:
ACC
(White) (Black)
http://www.usersmanualguide.com/
( 1A )
Ignition wire (Red) ª12V
Ground wire (Black) · (To car chassis)
(Accessory A)
Remove the protective sheet on
the black connector before the
KTC-V500E is connected.
(Accessory D)
( 1A )